. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 07-01-2016 #1
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    It's just a Spoil board so what's the issue.? Spoil board is meant to cut into it's no big deal.

    To Limit the end of travel makes sense if you can run the bearings or ballscrew off the end but just running a little deep into spoil board doesn't warrant limit switches and they can be more trouble than there worth on low end of Z axis.
    Last edited by JAZZCNC; 07-01-2016 at 08:06 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Wiring home and limit switches
    By Lee Roberts in forum General Electronics
    Replies: 24
    Last Post: 18-11-2023, 06:14 PM
  2. Wiring limit switches
    By Janste in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 10-02-2015, 10:37 AM
  3. EMC2 home/limit switches... only acting as limit?
    By vputz in forum LinuxCNC (EMC)
    Replies: 4
    Last Post: 15-10-2014, 09:51 AM
  4. Limit Switches with LED's
    By manofgresley in forum General Electronics
    Replies: 30
    Last Post: 02-01-2013, 03:08 PM
  5. Limit Switches
    By Lee Roberts in forum General Electronics
    Replies: 13
    Last Post: 27-06-2008, 02:21 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules