Stepper problem

[eurikain]

Try setting the step pulse in motor tuning to 5 set Dir to 0 You want the Step in front of the Dir.

Just tried, same problem.

However, when I started Mach3, ran the first test, the motor worked fine for about five seconds before going back to making the same noise as before. Notice that the motor now moves really slowly. When I move it to one direction, it takes several seconds to start, then to slow down. Mach3 indicates correct value as I can see on the screen that the motor takes forever to stop.

EDIT: go to zero function works fine. I'm guessing the bob is fine... may be it's the drivers :/ Oh boy... I think I'm just going to buy a new PSU, new drives, and get a nema23 8 leads to match the others I got...