Stepper problem

[JAZZCNC]

Ohhhh I see :) I know you told me that, but honestly, don't you think I am better off with AM882 and the good Nema23 from CNC4YOU ?

Yes I do but that wasn't your problem at the time so in that context then No. The reaity is that you may have found just fitting a Motion control card from the start would have full fulled all your needs.?

But now you have gone this far then I'd say finish it properly with Motion control card. Given the fact you have BoB's and it's router with slaved axis then I'd say ESS Smooth stepper. So drop George (Komatis) a line and he'll sort you out I'm sure.

[eurikain]

Thank you Jazz :) I will follow your instructions :)

[komatias]

Thanks for the promo Jazz!

Eurikain,

I will be in Antewerp over Christmas. If you are not in the area, I can pop an ESS in the Belgian post and save you a bit of money on postage from the UK

[eurikain]

Great ! Have family around ? Be careful, I've heard Belgium's not safe these days lol :D Oh Dear, I live 30 minutes away from Brussels :) I'll PM you so we save this thread some bad jokes :)

[JAZZCNC]

Thanks for the promo Jazz!

No problem just remember this( and the others) when I want one. .

[eurikain]

Lol, you're good ;)

[eurikain]

FYI, I tried with a friend of mine's parallel port PCI board, and it's the same problem ! So.... problem == MOTHERBOARD !!!!!!