Desktop size steel welded router 3 axis

[JAZZCNC]

It's the little details that eat the time but they also make the difference between just OK machine and great machine. This is well on way to being great machine so keep it up mate and no rushing.

[Tom J]

Thanks Jazz, SolidWorks helps a lot, I print the template before I drill any hole and cat any shape, use automatic puncher to be precise. Can not wait to the end.

[JAZZCNC]

Thanks Jazz, SolidWorks helps a lot, I print the template before I drill any hole and cat any shape, use automatic puncher to be precise. Can not wait to the end.

Yep I do the same paper and Spray mount it's priceless.!. . I even do the same On cnc machine some times when cutting parts out of large sheet just to be sure they'll fit and not waste material or clash with clamps etc. I then write Tap sizes etc for holes on sheet to remove chances of error etc.

[AndyGuid]

Thanks Jazz, SolidWorks helps a lot, I print the template before I drill any hole and cat any shape, use automatic puncher to be precise. Can not wait to the end.

Yep I do the same paper and Spray mount it's priceless.!. . I even do the same On CNC machine some times when cutting parts out of large sheet just to be sure they'll fit and not waste material or clash with clamps etc. I then write Tap sizes etc. for holes on sheet to remove chances of error etc.

Thanks chaps, for a desk based worker like me those are brilliant tips! I hadn't realised the benefits of an automatic puncher and I hadn't thought of printing a template. Now to see if the free version of Sketch-Up can print to scale? And find out what sort of spray mount to use?
.
.
.
"An automatic center punch is a hand tool used to produce a dimple in a workpiece (for example, a piece of metal). It performs the same function as an ordinary center punch but without the need for a hammer. When pressed against the workpiece, it stores energy in a spring, eventually releasing it as an impulse that drives the punch, producing the dimple. The impulse provided to the point of the punch is quite repeatable, allowing for uniform impressions to be made." https://en.wikipedia.org/wiki/Automatic_center_punch

[Tom J]

Got problem with proxy sensor in X axis - not too much room to fit.
Any recommendation for flat body type and 1-2mm range PNP NC like that:

[JAZZCNC]

I find the Round type better has they give more adjustment. Use traveling switch then you'll only need one per axis and it can travel with Z axis facing down there's plenty of room on back of there for a bracket and loads of room on top of gantry for targets.?

[Tom J]

Got some old alu plate - enough for table

Bed profile was 2.5mm thick before. Now after surface planing is a bit less so I used thread rivet to fit the table top.

M5 countersink bolts

One Y sensor for Home and Limit (PNP NC)