Desktop size steel welded router 3 axis

[Tom J]

Update to control panel

Previous USB controller XHC was working fine - only issues i had was with plug in - few bugs like homing stopping after each axis.
Never lost signal, no interferance
Home had to be pressed another time for Y and Z unless they are very close to home position.
Ref All Home
X axis which reached the home stopped homing and cause Reset.
Ref home again and the X axis which was in home moved a bit and and start homing Y
Y in home but and reset triggered, so home all again.
This will moved X for 2nd time, Y again for 1st time after being homed and start do Z
Now I have to back a bit XYZ and home all - only doing that was posible to home all in one go.
This was inconvenience to me so I moved to CSMiO -IP/M.

Does anybody got good software / plug-in? Tried few and still the same

Here is my new box