Thread: Old PC`s and Mach3
-
16-03-2018 #31
-
16-03-2018 #32
ah this wasn't part of the replace to fix it, its simply an upgrade I was looking at from the get go. I brought a cheap pci card to see if its the lpt port causing issues, just need to configure it properly and then I should be able to use the machine.
UC300 wont suit my requirements as it offers too much than what I will use it for but from £20 more from the UC100 I might as well get the UC400.
-
16-03-2018 #33
The UC400ETH is a little more than a UC100, and a UC300ETH is a little more than a UC400ETH.
Gerry
______________________________________________
UCCNC 2022 Screenset
Mach3 2010 Screenset
JointCAM - CAM for Woodworking Joints
-
16-03-2018 #34
-
17-03-2018 #35
That utility effectively over rides the laptop power management's propensity to slow down the CPU whenever possible to reduce power consumption, another common laptop problem is a parallel port voltage which proves marginal for driving external logic.
You have a laptop which can work with Mach3 through the parallel port, many will not and that's the reason laptops were not recommended or supported.You think that's too expensive? You're not a Model Engineer are you? :D
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Mach3
By petesos in forum Artsoft Mach (3 & 4)Replies: 3Last Post: 23-10-2012, 10:18 PM -
Mach3 and LCD
By dzero in forum General ElectronicsReplies: 3Last Post: 30-07-2012, 12:50 PM -
mach3 goes off the bed
By swinds in forum Artsoft Mach (3 & 4)Replies: 8Last Post: 17-01-2012, 11:43 PM -
mach3
By edgas10 in forum Artsoft Mach (3 & 4)Replies: 5Last Post: 27-04-2011, 11:18 PM -
MPG and Mach3
By GeoffV in forum Artsoft Mach (3 & 4)Replies: 13Last Post: 08-10-2010, 05:56 PM
Bookmarks