Surfacing Spoiler board

[CommanderKenyon]

Thanks For repies everybody ,

I've ordered a bit to get me started http://www.wealdentool.com/acatalog/..._Wing_250.html

the Video was very helpful Christian Thnx


Ill have a look at fusion and I've heard a few people use cambam good tip about the 40 openings if i am going to use a piece of software i don't mind paying , its just a pain when you don't take to software after you forked out for it

in to motion control I've been building a large delta 3d Printer Reciently and have a few smoothie boards here

http://smoothieware.org/smoothieboard

i have thought about putting one of those on my 6040 rather than use the std breakout board in the blue box, it does seem to work but many say the electronics can cause problems, I'm hoping the drivers and steppers will be ok in mine for now they are

leadshine microstep driversdm542-500
and
sumtor nema 23 57hs7630b4d8 1.8deg 3amp

it has a 1.5kw spindle that seems reasonable build quality ( but time will tell i guess)


i have replaced all the stepper wiring and cooling hoses as they were junk and had bad connections



thanks again for replys people hopefully i will get my first cuts done soon

mr.k