. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #14
    It is interesting to see how you have done this, as I have the Sino DRO as a factory fitted option to my Amadeal 290-VFF.


    I notice that the bracket on the cross slide will limit the tailstock. On my machine the read head is fitted into the recess of the saddle. This means that the tailstock can get closer to the chuck (only about 10mm further away than without the DRO). I seem to do a lot of centre drilling of short pieces, and I prefer to do it with as little stick out of the quill as possible.


    Here are a few pictures to show you what I mean.

    Click image for larger version. 

Name:	DSCF1715.JPG 
Views:	1688 
Size:	122.8 KB 
ID:	19541Click image for larger version. 

Name:	DSCF1716.JPG 
Views:	1623 
Size:	158.6 KB 
ID:	19542Click image for larger version. 

Name:	DSCF1717.JPG 
Views:	1601 
Size:	200.8 KB 
ID:	19543Click image for larger version. 

Name:	DSCF1718.JPG 
Views:	1643 
Size:	158.4 KB 
ID:	19544Click image for larger version. 

Name:	DSCF1720.JPG 
Views:	1638 
Size:	162.5 KB 
ID:	19545



    You may note that the cap-head screw that stops the tailstock smashing the DRO scale is bent and needs replacing. Also the gib screws are not accessible with a hex key and the cross slide lock can't be used. If I need to adjust the gib or lock the cross slide the easy answer would be to replace these with hex head screws, then you could just pop a spanner on them.


    I think the spacers that the factory fitted are a bit naff and would look better as a single piece. I may make something better if I ever dismantle the DRO fitting. The other thing I would do is tidy up the cable routing and use P clips rather than cable ties.

    As a last note - the red things are plugs in the T slots to stop coolant pissing over the apron and onto the floor and/or me. They are only red 'cos that's the colour ink I had in the 3D printer.



    Cheers,


    Rob
    Last edited by cropwell; 02-11-2016 at 12:54 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Backlash , Any suggestions ?
    By philgiggins in forum Linear & Rotary Motion
    Replies: 18
    Last Post: 13-10-2015, 07:31 PM
  2. Boring Bar Suggestions?
    By Washout in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 10
    Last Post: 21-06-2014, 08:59 AM
  3. Cooling pump suggestions
    By martin54 in forum General Electronics
    Replies: 2
    Last Post: 13-02-2013, 09:07 PM
  4. Power Supply Suggestions please..
    By Ricardoco in forum General Electronics
    Replies: 37
    Last Post: 30-01-2013, 06:37 PM
  5. Driver suggestions
    By Shinobiwan in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 04-03-2012, 03:54 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •