. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 13-11-2016 #16
    cropwell's Avatar
    Lives in Nottingham, United Kingdom.
    cropwell
    Last Activity: 28-05-2023 Has been a member for 9-10 years. Has a total post count of 1,646. Received thanks 170 times, giving thanks to others 30 times.
    Hi,

    I have the Sino SDS6-2V DRO so I cannot comment on the one you have, but on my DRO the 'Lathe Mode' is set up by interrupting the switch-on self check and after aload of 'enter' down arrow key presses, you can choose the machine type. Then, I believe the 1/2 button will work. It does for me ! I am only reading through the handbook.

    I would go and check it, but I am currently confined to barracks with a shoulder injury.

    R
    Last edited by cropwell; 13-11-2016 at 06:24 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Backlash , Any suggestions ?
    By philgiggins in forum Linear & Rotary Motion
    Replies: 18
    Last Post: 13-10-2015, 07:31 PM
  2. Boring Bar Suggestions?
    By Washout in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 10
    Last Post: 21-06-2014, 08:59 AM
  3. Cooling pump suggestions
    By martin54 in forum General Electronics
    Replies: 2
    Last Post: 13-02-2013, 09:07 PM
  4. Power Supply Suggestions please..
    By Ricardoco in forum General Electronics
    Replies: 37
    Last Post: 30-01-2013, 06:37 PM
  5. Driver suggestions
    By Shinobiwan in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 04-03-2012, 03:54 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules