. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 16-10-2015 #1
    routercnc's Avatar
    Lives in West Midlands, United Kingdom.
    routercnc
    Last Activity: 4 Days Ago Has been a member for 9-10 years. Has a total post count of 1,723. Received thanks 403 times, giving thanks to others 75 times. Referred 3 members to the community.
    Cheers Neal that's good to know.
    Building a CNC machine to make a better one since 2010 . . .
    MK1 (1st photo), MK2, MK3, MK4
    Reply With Quote Reply With Quote
  2. 16-10-2015 #2
    mekanik's Avatar
    Lives in Barrow in Furness, United Kingdom.
    mekanik
    Last Activity: 1 Week Ago Has been a member for 9-10 years. Has a total post count of 795. Received thanks 98 times, giving thanks to others 176 times.
    My only advice really is make sure you get one with a separate drive shaft for the saddle and cross slide. you are better of saving wear on the leadscrew so you can produce accurate screw threads.
    Regards
    Mike
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Backlash , Any suggestions ?
    By philgiggins in forum Linear & Rotary Motion
    Replies: 18
    Last Post: 13-10-2015, 07:31 PM
  2. Boring Bar Suggestions?
    By Washout in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 10
    Last Post: 21-06-2014, 08:59 AM
  3. Cooling pump suggestions
    By martin54 in forum General Electronics
    Replies: 2
    Last Post: 13-02-2013, 09:07 PM
  4. Power Supply Suggestions please..
    By Ricardoco in forum General Electronics
    Replies: 37
    Last Post: 30-01-2013, 06:37 PM
  5. Driver suggestions
    By Shinobiwan in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 04-03-2012, 03:54 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules