Threaded View
-
25-10-2015 #11
Thanks again everyone for the advice. Greatly appreciated.
At the moment I'm not 100% sure on which software route to go down. I'd probably shy aware from Linux at the moment as I have no experience with it. As CNC is new itself for me, I'd rather begin with an OS I know well.
The Planet CNC seems tempting to me currently as it looks like it could be a bit more beginner friendly.. what did you find was too basic about it?
The only thing is as mentioned, I'm not keen on not being to use other software with the board.. but maybe it's a price worth paying..
OK.. so if I go the planetCNC ethernet controller route.. what shall I do about the PC situation? Shall I build one using the Asus H61M-Pro I have coming or is the energy saving features going to make it completely unreliable? Or as I need a good PC there anyway, shall I just give it a go and if not then buy a cheap pentium 4 or something without the new features..? What would you do if you were me?
Thread Information
Users Browsing this Thread
There are currently 5 users browsing this thread. (0 members and 5 guests)
Similar Threads
-
USB TO Parallel Port DIY Interface
By Lee Roberts in forum Electronic Project BuildingReplies: 42Last Post: 17-02-2018, 07:46 PM -
What is the function of a parallel port breakout board?
By hbx in forum Machine Control SoftwareReplies: 13Last Post: 12-03-2013, 06:18 PM -
parallel port address
By Dan Brown in forum Artsoft Mach (3 & 4)Replies: 6Last Post: 07-01-2010, 12:04 PM -
Laptop, ie no parallel port?
By tompsky in forum Laptops & TabletsReplies: 3Last Post: 11-11-2008, 07:12 PM -
Which USB parallel port emulator is the best
By bruce_miranda in forum General ElectronicsReplies: 1Last Post: 18-09-2008, 03:38 PM
Bookmarks