Which vacuum cleaner (Karcher MV2?)

[d4cnc]

Haha, cheap to the point of .. 'where's the catch'.
Apparently it's very much a 'buy cheap rubbish from China and sell in a warehouse' type set up there.. so not sure I'd trust it to perform great.. but it should give me a good idea of what I need when I buy its replacement unit! - worst case scenario. Or best case scenario, it works great and for a long time!


I guess if it fails before 6 months, I can always get a refund, assuming I'm not misusing it.


Yes your system with hose seems exactly what I want to do. As you say, keeping it as close to the cutter I think is the key. Maybe even two if I have space..


Awesome. So that's a plan then! I've been stalling on building the table until I had a plan of sorts.. so will now start it I think. Off to the timber yard...!

[d4cnc]

One thing before buying that air compressor.. I assume it's an oil filled one.. which by all accounts are less noisy and run better. However require more maintenance. However I can't seem to find any info on what maintenance it will require..


Could any one shed any light on this for me? I've never actually used an air compressor before.