Thread: Putting Bearing on Drill
Threaded View
-
27-10-2015 #6
Last Activity: 06-07-2022
A design note here on the selection of bearings. For machine tools it is preferable to use shielded bearings to sealed. Rubber seals add friction and heat to the assembly that you could do without. Shields do not contact the inner race so they do not add too much friction and allow oil to seep through to the balls.
What you are experiencing with the assembly being notchy is probably out or roundness in the housing or some misalignment on the shaft itself.
Should not be difficult to figure out and save a few bob repairing it.Last edited by komatias; 27-10-2015 at 10:34 AM. Reason: spelling
https://emvioeng.com
Machine tools and 3D printing supplies. Expanding constantly.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Putting Neodymium Strong magnets near spindle ..is it ok ?
By RoyT in forum General DiscussionReplies: 3Last Post: 01-11-2014, 09:28 PM -
Bearing fit problem
By paulus.v in forum Linear & Rotary MotionReplies: 7Last Post: 09-10-2013, 09:54 AM -
Zapp 3-Axis kit - putting it all together
By birchy in forum Motor Drivers & ControllersReplies: 5Last Post: 18-02-2013, 12:05 PM -
Making timing pulley - putting theory into action
By wiatroda in forum Metalwork Project ShowcaseReplies: 15Last Post: 28-11-2011, 02:22 AM -
FOR SALE: bearing/belts
By oadamo in forum Items For SaleReplies: 9Last Post: 03-01-2011, 12:43 PM
Bookmarks