Thread: Putting Bearing on Drill
Hybrid View
-
28-10-2015 #1
Does anyone have tips on how to remove the chuck on my WD13S pillar drill from Axminster?
The spindle has a taper directly on the end and pressed into the chuck. There is no 'key way' to release it. Tapping a bearing release fork between the chuck and drill body only acts to pull the spindle out of its bearings.
Perhaps a bit of dis-assembly lubricant and heat on the chuck? Any other tips?
-
28-10-2015 #2
If you can lever off the bottom bearing you could try something like this.
http://www.tools-4-you.co.uk/Hand%20Tools/ball_tie.htm
If the bearing wasn't on the shaft a sharp strike to the back of the chuck should break it(the taper not the chuck)
Sorry about that missed the bit where you had tried the taper wedge tried to delete the message but couldn't
You could grip the shaft in the vice just behind the bearing (to prevent it moving) and try the wedge again.
Regards
MikeLast edited by mekanik; 28-10-2015 at 05:18 PM.
-
29-10-2015 #3
Well the wedges method is the preferred way, did you use two either side or just one, here is a link to the correct type, not sure whats going on with the price but I'm sure you can find others or make some: http://www.ebay.co.uk/itm/371117648999
Here is a great video by a friend I follow on YouTube, he's doing a service on a chuck, uses the wedges method correctly and takes you through the motions and more:
https://youtu.be/h_jQ7-UiWgI
.MeLast edited by Lee Roberts; 29-10-2015 at 05:07 PM.
.Me
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Putting Neodymium Strong magnets near spindle ..is it ok ?
By RoyT in forum General DiscussionReplies: 3Last Post: 01-11-2014, 09:28 PM -
Bearing fit problem
By paulus.v in forum Linear & Rotary MotionReplies: 7Last Post: 09-10-2013, 09:54 AM -
Zapp 3-Axis kit - putting it all together
By birchy in forum Motor Drivers & ControllersReplies: 5Last Post: 18-02-2013, 12:05 PM -
Making timing pulley - putting theory into action
By wiatroda in forum Metalwork Project ShowcaseReplies: 15Last Post: 28-11-2011, 02:22 AM -
FOR SALE: bearing/belts
By oadamo in forum Items For SaleReplies: 9Last Post: 03-01-2011, 12:43 PM
Bookmarks