. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 28-10-2015 #1
    mekanik's Avatar
    Lives in Barrow in Furness, United Kingdom.
    mekanik
    Last Activity: 1 Day Ago Has been a member for 9-10 years. Has a total post count of 789. Received thanks 98 times, giving thanks to others 176 times.
    If you can lever off the bottom bearing you could try something like this.

    http://www.tools-4-you.co.uk/Hand%20Tools/ball_tie.htm

    If the bearing wasn't on the shaft a sharp strike to the back of the chuck should break it(the taper not the chuck)

    Sorry about that missed the bit where you had tried the taper wedge tried to delete the message but couldn't
    You could grip the shaft in the vice just behind the bearing (to prevent it moving) and try the wedge again.
    Regards
    Mike
    Last edited by mekanik; 28-10-2015 at 05:18 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Putting Neodymium Strong magnets near spindle ..is it ok ?
    By RoyT in forum General Discussion
    Replies: 3
    Last Post: 01-11-2014, 09:28 PM
  2. Bearing fit problem
    By paulus.v in forum Linear & Rotary Motion
    Replies: 7
    Last Post: 09-10-2013, 09:54 AM
  3. Zapp 3-Axis kit - putting it all together
    By birchy in forum Motor Drivers & Controllers
    Replies: 5
    Last Post: 18-02-2013, 12:05 PM
  4. Making timing pulley - putting theory into action
    By wiatroda in forum Metalwork Project Showcase
    Replies: 15
    Last Post: 28-11-2011, 02:22 AM
  5. FOR SALE: bearing/belts
    By oadamo in forum Items For Sale
    Replies: 9
    Last Post: 03-01-2011, 12:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules