Hi JAZZCNC and everyone else reading.

Here's the latest update on the Emco.
I've painstakingly checked through wiring, connections, plugs, sockets, DIN rail connectors, more plugs........you get the picture! Nothing obviously wrong. Whilst visiting one of my customers, I discussed the issue with a couple of the guys there who install control systems to ultrasonic scanning machines. They both said the same as you, and suggested that I reroute the incoming power cables as far from any signal leads as possible, using SY flex of the correct size, also earthing the braid for extra protection from any EMFs.

They also suggested that I install ferrite beads on all signal cables as close to the terminals as possible.

After doing all this, I expected to triumphantly power up and be merrily machining within minutes.

No.

On switching the isolator on, there was a slight pop like a trip blowing from inside the enclosure, and now the machine does nothing. No screen, no initial run of the lube pump, zilch.

There is three phase in all the right places, the PSUs seem to be pumping out the correct voltages, the lights are on on the drive units, and the supply light is on on the CNC processor case. But no screen, it briefly changes colour on power up, but then reverts to black. Also, several of the LEDs on the softkeys are illuminated, which never happens on start up. Incidentally, none of the buttons, keys, knobs or dials now do anything.

It strikes me that the machine is doomed to failure. I cannot afford to scrap it, it is mechanically far too good for that. I either need to call in the experts, or seriously consider retrofitting a new control system, neither of which I can particularly afford at the moment, but I do need to get this machine producing.

I've tried contacting Emco, and it transpires that they don't actually have a UK service centre, or anyone who knows anything about this machine. Surprising.

Any ideas or suggestions at this point would be much appreciated. Could it be sheer coincidence that something else has gone kaput just at this time, or is there a simpler explanation?

Incidentally, does anyone know if I can purchase a complete retrofit package with a conversational control suitable for this machine? It is only 2 axis, with manual tool change.

Thanks in advance for any help!



Quote Originally Posted by JAZZCNC View Post
Yes Multi connectors are prime suspects. Also check pinch points on machine for crushed cables and areas where cables run close to heat and going brittle is common problem on older machines.
Broken shield wires on Connectors is also another common cause of false triggers thru loss of grounding. EMF will trigger e-stop easily and most other sensitive sensors.

PSU units on some of these Controls are very sensitive to power fluctuations so if your supply is a little up/down then this may answer your 24v report.

I bought a large milling machine with Anilam controller that had similair issue giving random reports and strange happenings just before it appeared to expire and give up the ghost on it's previous owner. Who thought the controller had died or more was actually told by so called Anilam engineer it was dead.! (He must have been a marvelous Engineer because he diagnosed all this on the Phone.!!)

Anyway to my good fortune this wasn't the case and was infact just 24v PSU that had gone down, all be it Very expensive PSU if bought from Anilam. It also had several other issues due to age like brittle broken wires, faulty/worn switches etc but none of these affected the control other than tricking it into false errors.
I have how ever since removed the control along with DC brushed servos/drives and currently retrofitting with modern controller and AC servos.