Thread: Boxford 165 HMC
Threaded View
-
22-11-2015 #7
For this purpose they have the, so called isolation card that is mounted on the side of the lenze controller heatsink. The 3wires left goes to lenze, the other to mains and 0-10V from CSMIO.
If the motor should run in rev than you must wait, until complete standstill and maybe half a second, before you can switch the direction. Eventually you can add a second photo sensor and wait until no signal changes occur. Lenze wants a zinkoxid varistor, don't ask what that is.
How do you have transformed the 5V from CSlab Controller to the 12V that the stepperdrivers want, I'll try to use the ULN2803 like in the 2 additonal stepper boards. But I don't know from the datasheet if they make a H or L output wih a H-input.Last edited by uli12us; 22-11-2015 at 04:25 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CONVERSION: Boxford TCL 160
By Saracen in forum Conversion Build LogsReplies: 38Last Post: 01-08-2021, 05:50 PM -
Boxford 260 VMC
By shoeswith in forum Boxford Vertical MillsReplies: 3Last Post: 10-04-2017, 06:20 PM -
eBay: Boxford 125 TCL
By magicniner in forum Items On eBay UKReplies: 0Last Post: 30-07-2014, 06:44 PM -
boxford vmc 300
By bigred5765 in forum Boxford Vertical MillsReplies: 0Last Post: 22-04-2014, 04:22 PM -
Boxford 160 TCL
By Brinner in forum Boxford LathesReplies: 1Last Post: 31-03-2012, 09:11 PM
Bookmarks