So the CSMIO controller is on its way lol, will take this thread as an opportunity to ask about new ideas for my new panel design.

question 1: I have acquired the Pilz PNOZ X5 , can it be used to connect safety reset , leadshine EM806 fault lines, VFD NC/NO connection in similar fashion as is described in the CSMIO manual?

question 2: I would like to use one power cable to hook all the components including VFD, will 1 wall outlet be enough to power 2.2KW VFD , 4 3.1Nm motors max 4A + misc 12V/24V power etc? sorry if it sounds dumb or like I didn't do my homework, I know the total power would be over the supplied 13A plug ( we use standard UK plugs here 220v) but because I have the oppurtinity to convert the wall outlet to a little bigger plug which has round pins and is rated 15A, in my humble opinion I think it will be rare to reach full power on spindle and all motors and everything at the same time right? in that case would either 13A or 15A be enough to power up the whole thing or should I use two wall sockets as I'm doing now?

question 3: is power line filter worth it for VFD?

question 4: is magnetic contactor helpful to power up the VFD? in my VFD manual it mentions it's safer or something in case braking transistor starts a fire ( I do plan on using the braking resistor ) so a setup with magnetic contactor controlled by the CSMIO worth it? or do they even do it like that?