CSLAB CSMIO/IP-M 4-axis Ethernet Motion Controller

[Tom J]

Resonance is why they stall on the bench but work fine on machine. With cheap Analog drives like those from Longs then it's worse than with better quality drives and much worse than Digital drives.

If those drives where Digital then on machine you'd reach 7-8mtr/min and have much smoother performance.

If your only getting 1.5Mtr/min on machine and sure all your tuning/setup is correct then I'd start looking for some serious binding.?

How did you wire the Motors parallel or Series.?

Why the Voltage isn't displaying I'm not sure it could be the plug-in or PC. Make sure your running Mach3 as Admin.

Thanks Dean

Those drive meant to be digital 'DM' but they are fake (they do not have autotuning like Leadshine) dodgy ebay seller:(

Only getting 1.5m/min on bench, on Machine 5.1m worst axis, 7m easy on Z, all with genuine digital drive.

Motor wired as described - Bi-Polar Parraller (8 cables)

Mach runs as Admin, tried both laptop same result - seen video without those reading