Threaded View
-
07-11-2015 #3
Here is the BOB manual. It seems to me that there is only one enable pin. Otherwise you have to use the 4 pin serial connectors, which I have no idea where to get the matching males..
Also, I have done a search on the forum, but the search engine is not so good. I haven't found a thread that explained that type of information :/ You know the forum better than I do ^^ I have had this search problem since I started using the forum. I mean, honestly, even using the advanced search with "control box" returns 20 pages of threads among which the first 3 pages haven't given me any clue...
I have a schematic diagram on its way, not ready yet. But wiring is not really my issue so far, as I understand quite clearly the big picture and have ready the AM882 manual, BOB manual, and the thread talking about the 2.2kw chinese spindles (so I got most of the info needed on that side). Once it's ready I will post it on here to get it checked by you guys.Last edited by eurikain; 07-11-2015 at 05:23 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What connectors?
By Neale in forum General ElectronicsReplies: 4Last Post: 07-07-2015, 12:21 PM -
Wiring a Corner finder and height control
By D-man in forum Probing, Digitizing & ScaningReplies: 38Last Post: 02-11-2014, 03:41 PM -
CY cable terminals
By kingcreaky in forum Marketplace DiscussionReplies: 15Last Post: 26-03-2014, 08:24 AM -
Connectors for steppermotors....any recomendations
By NICKMODELMAKER in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 06-06-2010, 04:51 PM -
Driver wiring to my computer for mach3 to control
By AdCNC in forum Motor Drivers & ControllersReplies: 13Last Post: 01-04-2010, 12:27 AM
Bookmarks