Where can I get this made?

[cropwell]

Anyway, I need to find a U-shaped bit of steel (channel) around 35mm high x 35mm long with the channel width internally about 6.5 +.5/-0 formed from 0.8 - 1mm sheet. Needs to be magnetic, so has to be steel, and finished in a brushed/satin effect.

How many do you need ?

[cropwell]

Hi Irving,

I have just cut and bent this. it is 7mm inside (but springs inwards to 5mm at open end) 40mm x 34mm at the moment. I need to deburr and finish. If it is too long let me know. Otherwise I need a quantity on this order and a despatch address as a PM.

There is the option of a black neoprene (?) foam 1mm thick if you want it lined with it. I can also offer cork and neoprene gasket if that would be better.

Cheers,

Rob

[irving2008]

Rob,That's brilliant, thank you. I need two identical ones. It has to fit over 6mm glass so 7mm with something internal like a thin neoprene sheet would be fine, as long as it stays put. 1mm neoprene might be a little thick though. Being pedantic, the only thing I'm not sure about is how tight that will sit against the edge of the glass, the commercially available, but too small, ones look squarer in profile


.
Is it magnetic? Or will I n<script id="gpt-impl-0.25115873216392326" src="http://partner.googleadservices.com/gpt/pubads_impl_75.js"></script>eed to glue some thin steel sheet to the back?
.
PM on its way.