3040T CNC Router Control box .. ..

[JAZZCNC]

Hi S

Probably nothing to worry about if it looks purposefully cut but if your unsure and don't want to risk turning on then post a good picture of the area your looking at and we'll take a look.

[Musicmanager]

Hi Jazz

Thanks for taking the trouble .. ..







Hopefully, that shows you what you need ... .. The pin is marked EDO, if that helps

I'm not too keen on the idea of blowing it up before I've cut something !!

Thanks again

S

[Clive S]

Perhaps its the enable opto and there is a design fault on the board and they have cut it to isolate it.

[JAZZCNC]

Ok well I think your good to go because I've seen this board mentioned before on CNCzone and the Eno Opto is related to the 4th axis output of the controller.
See this post. http://www.cnczone.com/forums/pcb-mi...-software.html

He mentions it being cut on this board and he's traced it back to the 4th axis output connector.

[Musicmanager]

Great information, thanks very much .. ..

I'll give it a go now .. :)

Thanks Jazz

S

[JAZZCNC]

Great information, thanks very much .. ..

I'll give it a go now .. :)

Thanks Jazz

S

Your Welcome and hope it works ok.! . . But if not just take Solice in knowing that often with these controllers it's was only a matter of when not if it goes bang.

[Musicmanager]

Ah, right !
So given the main purpose of this machine is to make PCB's for my electronics hobby, perhaps I should factor in a new controller box to my development plan !

More good information, Thanks again .. .. .

S