Threaded View
-
13-11-2015 #4
Last Activity: 1 Day Ago
Perhaps its the enable opto and there is a design fault on the board and they have cut it to isolate it.
..Clive
The more you know, The better you know, How little you know
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
SOFTWARE NEEDED TO RUN My CNC 3040T
By owen3371 in forum Machine Control SoftwareReplies: 5Last Post: 22-02-2020, 03:38 AM -
Cnc 3040t
By etNick studio in forum Milling Machines, Builds & ConversionsReplies: 7Last Post: 15-11-2014, 10:55 AM -
Chinese 3040T Arrives
By Gregor in forum Workshop & EquipmentReplies: 114Last Post: 11-07-2014, 05:55 PM -
DIY CNC router illuminated control panel
By wiatroda in forum Electronic Project BuildingReplies: 5Last Post: 04-06-2014, 11:19 AM -
servo control vs stepper control
By Peter. in forum Motor Drivers & ControllersReplies: 24Last Post: 17-09-2012, 08:36 AM
Bookmarks