Thread: Anyone using CNCdrive products?
Threaded View
-
15-11-2015 #1
Ihave a mill that was Fanuc controlled. It still has the Fanuc AC servos fitted, and I'd quite like to keep AC servos on the machine, and run it using MACH3.
From the info on there website it looks like the CNCdrive AC servo drive will run the Fanuc servo ok (just might need to change the encoder to a standard 2500ppr one)
It looks like CNCdrive do all the parts needed (including an industrial PC) and at very good prices, but there doesn't seem to be much about them on any of the forums.
Would like to know if their stuff is any good and if anyone has any experience of it??
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CNCdrive.com Cheap Servo drives
By BillTodd in forum Marketplace DiscussionReplies: 2Last Post: 13-06-2017, 11:38 AM -
Advice requested for these products and any suggestions; Links below
By mordy in forum Motor Drivers & ControllersReplies: 26Last Post: 14-06-2015, 01:49 PM -
Corian and similar products
By Fivetide in forum General DiscussionReplies: 8Last Post: 20-10-2012, 03:36 PM
Bookmarks