Electronics for New Machine + Chinese Spindle + VFD

[JAZZCNC]

Depends on ballscrew pitch and Volts your running steppers at. But given it's relatively light weight construction ie not heavy gantry and using External motion controller then some thing like below.

If 10mm pitch and say 60-70V then you should easily velocity at 10mtr/min and would proababy max out around 14-15mtr/min. Maybe slightly less on the Y axis. With Accel of roughly 800-1000. Just remember can't have both high Vel and high Accel.

If 5mm pitch and 60-70v then roughly half the above velocity figures. With slightly less Accel.

If less volts then slightly less speed but with around 40-50V I'd only expect about 15-20% less.

How you tune the motors will depend on several factors like type of work you'll be doing etc. Good all round setup for such a small machine would be Max velocity of 8000mm/min with Accel around 1200-1500.
This is based on 10mm pitch/60-70v. It will give you good balance of speed and accel along with reliabilty.

Nice job by the way and you'll make some nice stuff with that. Well done. .