Electronics for New Machine + Chinese Spindle + VFD

[Clive S]

Martin

Have you thought about how you will operated the VFD controls, in my opinion I would not mount the VFD inside the control box.
All the grounding sheaths should go to one central point ie star to avoid ground loops. The drivers should not be daisy chained like you have shown take each driver supply back to the PS. It is generally not needed to screen the signal wires (I tend to use cat5) You don't show any E-stop.
.
Keep the cables from the drivers to the steppers as far away as possible from any signal wires.
.
Good luck with the build.

[mturneruk]

Thanks guys.

Is it to small because of EMI or because of heat ?

It's vented and i was going to chuck a couple of fans on it.

I decided that all cables in the box would be shielded.

Also i was going to make cut outs around the VFD and 3d print some additional vent covers to increase airflow.

I am planning on removing the touch buttons from the VFD which comes off as a unit attached to a ribbon cable and mounting that on the outside...

Not arguing with you, just wanted to understand the logic.

Cheers
Martin