Electronics for New Machine + Chinese Spindle + VFD

[JAZZCNC]

It's not so much a bug rather less than perfect way mach homes with slaved motors and your actions while homing.
When homing mach de-couples slaved axis meaning they work as separate axis again. When you interuppted the homing sequence mach is still in de-couple mode so when you jog it only moves that axis, in your case Y.

If you had pushed E-stop and reset mach then this probably wouldn't have happened because the home script would have been cancelled.

However there is a possible work around if you want to prevent it happening.? I haven't tested this but sure it will work.
You can change the homing script and turn off Jogging while homing. To do this use this command at the start and end of the homing script.
DoOEMButton(103)

To do this go to Operator menu and select Edit button script. This will start the Ref-all-home button flashing. Click on it and script editor will open.
Insert DoOEMButton(103) at the beginning and end of the script then save it.

Now it should toggle Jog off while homing and toggle back on when finished. Obvisouly you won't be able to jog if you press stop or cancel homing. Also you may have to turn Jog back on manualy because it won't get toggled back on because the home script didn't finish.

Try it there's nothing to lose.