Martin,

sounds promising.

Quote Originally Posted by JAZZCNC View Post
If you have Home switch's then you shouldn't have to do that.? The control software should allow you to save the WORK offset before each Job then it's simple case of HOME the machine if you E-stop or Reset. That's the whole purpose of HOME switches so you can return and have multiple WORK offsets and easily go to them using Gcode.

No machine should be without HOME switches IMO they are priceless at times.
Yup just like I told him. Very important point there too, when you reset or e-stop, you must always assume you have lost position.

Martin is using UCCNC so I could not help with saving the work offsets like you would in Mach. Never used it myself.