Threaded View
-
23-11-2015 #1
Hi,
Just a quick question, I have my AM882 setup as follows.
Alarm is set to active low and Enable is set to active high.
The question is if the AM882 is not receiving an enable signal then it appears to trigger the alarm. Is this correct as manual only states that the alarm signal will only trigger on the following errors "Alarm signal: OC output signal, activated when over-voltage, over current, under-voltage, phase-error and stall-error protection."
If i supply the Enable contact the red alarm led stops flashing, and as soon as i cut power to the enable it starts flashing again.
Although ive not got a motor connected so could it be a "Phase Error Protection" alarm thats actually triggering?
Regards
TrevLast edited by Gotty101; 23-11-2015 at 10:46 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Wiring up the Alarm output on Leadshine AM882
By Shinobiwan in forum Motor Drivers & ControllersReplies: 42Last Post: 01-08-2017, 02:07 AM -
Need to slow down a signal due to Safe Torque Off alarm
By corkcnc in forum General ElectronicsReplies: 0Last Post: 04-06-2014, 11:35 PM -
AM882 Alarm Circuit
By Wobblycogs in forum General ElectronicsReplies: 8Last Post: 28-03-2014, 06:06 PM -
Mach3 and its enable function
By GeorgeD in forum Artsoft Mach (3 & 4)Replies: 0Last Post: 12-07-2010, 09:47 PM -
+5V TTL Signal
By NC-Joey in forum General ElectronicsReplies: 2Last Post: 12-08-2007, 02:46 PM
Bookmarks