inspiration thread

[routercnc]

Hi Neil,

Good to see some liteply being cut - very satisfying to plug bits together using the tabs etc. and have it build almost in your hands. I know what you mean about mixing the inside profile and outside profile in CAM toolpaths. So easy to do and very annoying!

It's been a while since I cut that material (more aluminium recently, plus some MDF and thick plywood) but my cutting speeds were much faster than that and quality was OK. Worth experimenting a bit more? I don't have much time in the workshop so time is precious.

What cutter is that? I use a 2 'blade' TCT 3mm super cheap e-bay bit and it works fine.

Thanks

[njhussey]

Hi Neil,

Good to see some liteply being cut - very satisfying to plug bits together using the tabs etc. and have it build almost in your hands. I know what you mean about mixing the inside profile and outside profile in CAM toolpaths. So easy to do and very annoying!

It's been a while since I cut that material (more aluminium recently, plus some MDF and thick plywood) but my cutting speeds were much faster than that and quality was OK. Worth experimenting a bit more? I don't have much time in the workshop so time is precious.

What cutter is that? I use a 2 'blade' TCT 3mm super cheap e-bay bit and it works fine.

Thanks

Barry.....sped it up a bit....this better?!

[Clive S]

Neil looking much better federate now. keep up the good work.

[njhussey]

Neil looking much better federate now. keep up the good work.

Cheers Clive

[routercnc]

Sorry been offline
Looking better now great work

[Jonathan]

Does this count?



Not so much inspiration as needing to get on with it!

[GEOFFREY]

Of course it counts Jonathan, it looks great, but lets see it in action now. G.