. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 28-11-2015 #2
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Doubt it will be the cable. Usually a dodgy cable will work but give strange results.
    Mach will work just has if the machine was alive because it knows or told no different so it will be sending pulses just the same but no ones listening.!!

    Chances are it will be either a BOB or Drive problem. Possibly a blown fuse to PSU for BOB which would stop all signals going to the drives.
    Or has often the case with these Chinese machines if using TB based All-in-One drives and if not PSU related it could be dead.!!

    Could be a Broken wire so look very carefully.
    Last edited by JAZZCNC; 28-11-2015 at 07:42 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. stepper motors
    By reefy86 in forum Gantry/Router Machines & Building
    Replies: 4
    Last Post: 06-09-2015, 12:54 PM
  2. Stepper motors - problem
    By dudz in forum Stepper & Servo Motors
    Replies: 7
    Last Post: 13-02-2013, 07:07 PM
  3. Help with Stepper Motors
    By Scott in forum Stepper & Servo Motors
    Replies: 8
    Last Post: 04-04-2010, 02:35 PM
  4. rs stepper motors
    By chaz@2b in forum Stepper & Servo Motors
    Replies: 19
    Last Post: 06-08-2009, 11:05 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules