Thread: Parallel ports problems
Threaded View
-
15-12-2015 #22
I am echoing Jazz's comment. You can get a submersible pond pump for a few quid and it will run all day and everyday till it wears out.
For instance :-
http://www.ebay.co.uk/itm/Submersibl...oAAOSw-jhT-EOI
Another comment about car washer pumps is that they are high pressure (ish) low volume pumps and the way they are constructed means that any swarf will likely destroy them. Also if you run them dry the rubber vanes inside will fail very quickly. Pond pumps have the advantage that you just chuck 'em in the tank. Anything else needs plumbing.
I have just scrounged a 120mm PC cooling radiator, and that is going in the circuit.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
usb - parallel
By universally in forum Gantry/Router Machines & BuildingReplies: 4Last Post: 12-03-2015, 04:03 PM -
Mach3 ports and pin setup to match my control box
By Sparky in forum Artsoft Mach (3 & 4)Replies: 17Last Post: 13-11-2014, 04:00 PM -
New Motherboards and LTP1 ports. (You might have one)
By Mattbatt in forum General ElectronicsReplies: 0Last Post: 05-04-2013, 10:12 AM -
ports and pins for system4
By Dan Brown in forum Motor Drivers & ControllersReplies: 2Last Post: 18-01-2010, 06:37 PM -
Ports and pins help ? mach 3
By xchipx in forum Artsoft Mach (3 & 4)Replies: 0Last Post: 19-04-2009, 12:45 PM
Bookmarks