Thread: Thread milling shallow bind hole
-
11-12-2015 #11
Hi Clive
Tar very much for the thought. Your question is a good one. I was looking to remove them but that may only be if something fails and the job needs breaking down. I will not dismiss opening the hole up slight larger and getting out the epoxy. Thanks for your help and waves of thought!
Steve
-
11-12-2015 #12
-
11-12-2015 #13
Hello Komatias,
Thank you for your reply. I realize I am not on the direct road for success, with the following
small diameter, shallow blind hole, in 316 no less, limited knowledge and wanting to thread mill it. All that said I may have a go at it.
Thanks
Steve
-
11-12-2015 #14
Hi Neil,
I am not sure so don't quote me on it but I think I got my ones from J&L. I notice you mention thread mills and good sport I notice you don't mention 316 in the same sentence!
I was watching one of your videos earlier in the inspiration thread you build looked to work out a treat for you.
Cheers
Steve
-
11-12-2015 #15
Hi Mike,
Yes thanks for the thought. I will certainly have practise before picking up the finished parts. The parts are for finishing off nicely m12 stud that protrudes a flat surface. Basically, just a blanking cap.
Many thanks
Steve
-
11-12-2015 #16https://emvioeng.com
Machine tools and 3D printing supplies. Expanding constantly.
-
11-12-2015 #17
Best of luck with that mate. Who know if my findings from my efforts are not too shameful I may post them! After this little job I hope to start a small router build!
-
12-12-2015 #18
-
12-12-2015 #19
-
The Following User Says Thank You to mekanik For This Useful Post:
-
13-12-2015 #20
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
solidoworks tapped thread depth and blind hole depth
By reefy86 in forum CAD & CAM SoftwareReplies: 2Last Post: 10-11-2015, 04:14 PM -
Tips and tricks for shallow milling/ engraving ?
By Gasgasbones in forum General DiscussionReplies: 17Last Post: 11-01-2015, 09:39 PM -
Hole Radius
By benkat in forum Machine DiscussionReplies: 0Last Post: 03-03-2014, 05:29 PM -
SBR16UU Centre hole.
By cambesol in forum Rails, Guideways & BearingsReplies: 3Last Post: 25-11-2013, 05:39 PM -
6mm shaft to 6.35mm hole?
By JuKu in forum Metalwork DiscussionReplies: 3Last Post: 15-12-2012, 02:29 PM
Bookmarks