Thread: Coolant Pump
-
17-12-2015 #11
if you want a detailed conversation about a triac then I have plans to add an 10 station atc, it should fit right on without altering the atc setup
(I have some better drawings on my other laptop)
-
18-12-2015 #12
-
18-12-2015 #13
-
19-12-2015 #14
no, new drive system and add a stepper motor
-
20-12-2015 #15
-
20-12-2015 #16
best I could do sorry, didn't do any machining this weekend
-
21-12-2015 #17
Thanks. Very helpful. You motor is on top whilst mine is in the cavity lower down (the full coolant system) so mine will have to pump a bit higher but not a lot more.
I could try and fix the motor setup I have, could machine a new based for it but probably not worth the effort. Id probably go for the 1/4 HP motor if I can get it to fit without cutting the sheetmetal.
Thanks once again.
-
07-01-2016 #18
-
07-01-2016 #19
-
07-01-2016 #20
I haven't but I will put all the dimensions on here when I get my tray back. It had obviously been left with coolant in it for some time before I bought it, all the water had evaporated off and the oil stripped the paint from the bottom of the tank. It is at the local bodyshop being stripped and powder coated.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Coolant, I am not sure which one to go with.
By suesi34e in forum Swarf & Chip ManagementReplies: 23Last Post: 17-10-2015, 07:13 PM -
My Coolant System
By Tenson in forum Swarf & Chip ManagementReplies: 6Last Post: 08-04-2013, 01:59 PM -
Washing Machine Pump Coolant System
By Lee Roberts in forum Electronic Project BuildingReplies: 7Last Post: 05-05-2012, 01:30 AM -
coolant
By luke11cnc in forum Machine DiscussionReplies: 4Last Post: 11-02-2012, 01:17 PM -
What coolant to use??
By don_jarr in forum General DiscussionReplies: 13Last Post: 05-11-2011, 03:12 PM
Bookmarks