Quote Originally Posted by Zeeflyboy View Post
Awesome as always...

Just curious - clearly you are pilfering quite a few bits like screws from your current machine.... given that your current machine is clearly not half bad, wouldn't it make more sense to buy all new parts for the new machine, therefore keeping the old one operational and then selling it as a working machine on here?
I had to read that a few times - thought by screws you meant fasteners (!). OK, ballscrews, right . . .

Good question and yes that was an option but there are several reasons:
It might not look like it but the current machine is actually on it's last legs in several areas. It is on a knife edge for aluminium and I have to keep the feeds low, intervening regularly. Things improved a year or so ago when I replaced the Z axis rails (15 mm miniature rails) as these had developed free-play. But it has started chattering again and I think that 15 mm miniature rails are just too weak. The linear bearings on one leg of the gantry has also developed free-play which is probably not helping. Because I know the machine I can work around these and keep it dialed in, but I'd feel bad handing this onto someone else, especially a beginner.

Before final de-commissioning I intend to make a video of various cuts at different F&S and depths etc., showing the maximum performance and all the noises it makes. Also measure the stiffness of the machine one last time. Then (some time later) repeat on the new machine, and hopeful see some improvement.

I also re-built the bed some time ago to make it much stiffer. The new machine support rails have been designed to drop straight onto the old bed so I would like to re-use that and save making someone again. That much aluminium profile, especially the heavy gauge stuff that I have, is quite pricey.

So once the bed has been re-used, that only leaves the gantry (which I will re-use the 20 mm linear rails on as these seem OK) and the Z axis (for which the rails are earmarked for the sliding part of an ATC carousel as that is all they are good for). The various bits of plate will be used for future projects, including a few parts for the new machine once operational.

I have sold parts of earlier machines on ebay, but this time around I was happy to just migrate the good bits across to the new one and keep this hobby ticking along.