Here we go again . . . MK4

[gojones]

The major benefit of this design is the ability to machine a workpiece that is way larger than you could fit in a conventional fixed gantry mill. You could place one end of a 20' beam on the bed and machine one end, or even machine the entire length in stages.

[routercnc]

Since I have an air compressor . . . I decided it was about time !

[rhay80]

As per the YouTube comment, here are some pics of my cool mist set up, but for my manual milling machine.

[Clive S]

Those water filters will take 8 bar it will probably say that on the box and the little screw on RH side is for letting the air out (priming) when being used as a water filter .

Nice vid.

[routercnc]

OK good to know thank you