Quote Originally Posted by Clive S View Post
Did you by any chance stop it in a canned cycle I have a feeling that it happened to me once.
I don't think so - I'll check the g-code when I get home as I wrote down the line number I stopped it on. I seem to remember lots of X and Y positional commands so probably not in canned cycle? It was cutting out the outline profile to a part which was almost a rectangle.

The last feedhold problem was done on a pass which had tabs on it, but it was about 50mm away from having gone up, across, and down to create the tab and was going in a straight line to the corner. I was about 20mm from the corner going X- when I pressed feedhold. Upon starting it went Y+ as if it thought it had reached the corner.

Next time I'm in the workshop I'll do some air cuts on the same file to see if I pressed the feedhold twice or something . . .