Here we go again . . . MK4

[njhussey]

Nice looking clamps! I'm about to change the way I cut the kits for eBay, instead of using masking tape to hold them down on the bed I'm going to cut out the 915mm x 102mm (by whatever depth the balsa is, 1.6 & 2.4mm) out of a piece of MDF and then using a cutter twice the diameter I normally use (2mm in this case) rout out 1mm deep the programming so that when I cut the wing ribs or fuselage sides I can send the cutter up to 1mm below the wood to ensure I cut all the way through. I'll be making holding clamps (sorry about all the waffle to lead up to the clamps I'm going to be making!!!) the same shape as single servo horns which I can swivel over the balsa to hold it...going to use some scrap 4mm Ali I've got lying around...hope that makes sense? :)

[routercnc]

Hi Neil,

If you mean using a spoil board then I'd agree that is a better way and one that I use as well for balsa/liteply.