Hi, I've not actually turned it on yet, so am just going on what I've heard others say about the electronics not being up to scratch on it.. for example, motors stalling easily, missed steps etc..


So my thinking was, as it's my first experience of CNCing, to just get hold of whatever I need to make sure there's not too many problems ahead of my first use..


So perhaps I'll just get the shielded CY 1mm˛ cable (as it's too short at the moment to reach the control box and VFD, and then power up and use it and take it from there!

(Fred.. what made you upgrade the drivers in your machine?)