I have a problem with motor direction. All motors turns forward/backwards but not responding for Dir LowActive.
I use keyboard, my machine layout is:
X (left-,right+)
Y (back+, forward-)
Z (up+, down-)
Orgin in bottom left corner - how I see it

Only Z works like I wanted
YX moved opposite and DRO reads negative value.
I checked all cables all connected like in manual and this thread.
For X:
pin1: DIR+
pin14: DIR-
pin2: STEP+
pin15: STEP-

Step Port: 0
Dir Port: 0

Have tried different output pins in Mach 'Motor Outputs'
I do not want swap the cables over, can't find proper guide how to set the pins either.
Any help appreciated.
Thanks