First time build - Steel Frame CNC Router

[examorph]

After much hair pulling I think I have finally started getting my head around some of this electronics! Please could you guys cast your eyes over the attached schematic for me to ensure I don't see any of this rumored 'magic smoke' come from the electronics, or worse yet...my head?!

Most of its based on a circuit diagram Dean posted for another user a while back and connections based on various instruction manuals and confirmed against Joe's schematics. Some things I was unsure about were things like daisy chaining some of the wires (eg at the fuses/terminal blocks), if connecting shield wire earths in series on the limits was OK and if the alarm terminals on the drives only applied if using a safety relay?

Also, I know you recommended 6.1Nm NEMA 34 for the X axis but would I be OK going with the 8.7Nm instead as per Joe's build? As this would let me buy all motors from one supplier (CNC4YOU). Thanks.

Schematics