Advice needed for controller box layout

[JAZZCNC]

Im glad you said that about the safety relays, I can see the importance of them but that will only complicate my build at this stage.

Sorry but Jim is WRONG to say it's not needed it very much is and it's not complicated or expensive.!!

[Bustercnc]

Understood Jim, I thought the estop button was hard wired but now I think about it, its only configured as such in the software and can be over ridden. I will be sure to add this along with fuses.

I did consider getting the next case up from mine but just wanted to keep it compact and simple as its just for PCB work with a cutting area of 200x150

My head hurts now , think Im going to just put my feet up now and enjoy a beer and probably google the stuffing out of this.

I really appreciate all the comments so far.

Cheers Dave

[Bustercnc]

Have you thought about safety relay, estop, fuses etc

Safety relay, I get it now. I hadn't thought that deepely about it, I assumed the estop and circuit breaker would be good enough.