Threaded View
-
08-01-2016 #11
Jazzcnc comment stuck with me and I felt kinda insulted by it.
Afterwards I spent many hours reading forums and manufacturer specs in fear of duplicating many of the stupid/repeat questions already asked, it dawned on me, what kind of person is going to stick their hand infront of a drill bit when something goes wrong? instink dictates that you would pull the plug in the event of the estop failing.
No matter how many safety features are employed, the above will still happen unless a trip switch is fitted on a enclosure door, NOT mentioned in all that I have read so far
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Advice on a charge controller please :)
By blackburn mark in forum General ElectronicsReplies: 23Last Post: 04-05-2020, 07:28 PM -
Help needed Dahlgren System 4824 And a DSC controller, what software will run it???
By fraserguitars in forum Machine DiscussionReplies: 0Last Post: 13-12-2015, 08:22 PM -
USB/Ethernet controller for Mach3/4 advice
By paulus.v in forum Control Hardware & SystemsReplies: 17Last Post: 17-02-2015, 09:37 PM -
Advice please! JAF Motion Controller issues!
By Mark Chard in forum Machine Control SoftwareReplies: 0Last Post: 31-01-2014, 05:03 PM -
Which controller and motors? Newbie advice please
By Nealieboyee in forum Motor Drivers & ControllersReplies: 14Last Post: 16-10-2012, 02:56 PM
Bookmarks