. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 07-01-2016 #3
    Bustercnc's Avatar
    Lives in London, United Kingdom.
    Bustercnc
    Last Activity: 05-10-2016 Has been a member for 9-10 years. Has a total post count of 14.
    Hi Jim,

    Thanks for the quick reply.

    I did look at mounting the power supply veritally but the lock on the door hits the top of the PSU on one side and on the other there is a bar which sticks proud of the door panel visible in the second picture next to the gounding wire, which also hits the top of the PSU meaning I have to move the PSU more to the centre of the case.
    Besides, being lazy I wanted it flat so I can easily access the screw terinals

    Cheers
    Dave
    Last edited by Bustercnc; 07-01-2016 at 04:41 PM. Reason: spelling mistake
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Advice on a charge controller please :)
    By blackburn mark in forum General Electronics
    Replies: 23
    Last Post: 04-05-2020, 07:28 PM
  2. Help needed Dahlgren System 4824 And a DSC controller, what software will run it???
    By fraserguitars in forum Machine Discussion
    Replies: 0
    Last Post: 13-12-2015, 08:22 PM
  3. USB/Ethernet controller for Mach3/4 advice
    By paulus.v in forum Control Hardware & Systems
    Replies: 17
    Last Post: 17-02-2015, 09:37 PM
  4. Advice please! JAF Motion Controller issues!
    By Mark Chard in forum Machine Control Software
    Replies: 0
    Last Post: 31-01-2014, 05:03 PM
  5. Which controller and motors? Newbie advice please
    By Nealieboyee in forum Motor Drivers & Controllers
    Replies: 14
    Last Post: 16-10-2012, 02:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules