Advice needed for controller box layout

[Bustercnc]

If my previous post gave the impression that a hardware safety circuit is not needed and software is fine, then I apologise. That was not what I intended.

Cheers,
Jim

No worries Jim, I have a AMA25LV Mill which I converted myself a couple of years back. I am ashamed to say I neglected any such failsafe features there as well and opted for "Strategy 1". Lesson learned, I will correct this when/if I ever get it set up again.

Trev - Your box looks great. Do you have any details of you custom PCB you made? I am interested as I am designing a fail safe circuit right now based on the sample one from the Mach3 manual and EddyCurrent's build thread (http://www.mycncuk.com/threads/6565-Ready-Steady-Eddy).

Hi Trev, I would be interested in seeing the circuit diagarm for your custom PCB if possible.

Good luck with your move, sounds ilke you are in the same boat as me, although I moved out 6 months ago and still not in my new house. Yellowbox storage are charging me a fortune. Yep, I read your thread from start to finish last night.

Cheers
Dave.