Thread: Mach 3 default settings,
Threaded View
-
07-01-2016 #1
Hi, I have got the machine axes connected tonight to the csmio and powered up to test all was good apart from y axis no movement so x,z and a good (x needs reversing changing the setting to low made no difference) that is now a small problem as I tried the CS labs mpg unit and its lumpy in the movements so I read on forum that the mpg sets up its own settings when installed and you do not need to enable MPG#1 but when I installed the plugin I set it to enable, so
i put it back to "not enabled" and all my settings for the machine have gone even the default IP address!!
i set channels for motors and try to save but get " wrong value in axis encoder PPR value" message I have guessed at a few numbers but no luck have I completely wiped this motion controller of life??
or is there a download that can restore basic info as the info I had wasn't far from default?
thanks for any help,
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Dip Switch settings on the M542 stepper motor drivers
By manofgresley in forum Motor Drivers & ControllersReplies: 13Last Post: 04-01-2021, 09:10 PM -
Saving machine settings between sessions
By Neale in forum Machine Control SoftwareReplies: 19Last Post: 07-05-2014, 08:17 PM -
Pulse rate or dip switch settings
By Jopo in forum Stepper & Servo MotorsReplies: 0Last Post: 29-04-2013, 08:08 AM -
Help with settings!
By Tenson in forum General DiscussionReplies: 26Last Post: 30-09-2012, 11:26 PM -
Calculating torque settings for bolts.
By swarf-boy in forum Machine DiscussionReplies: 2Last Post: 22-12-2010, 12:18 AM
Bookmarks