Threaded View
-
09-01-2016 #1
Hi there
I've got generator module and stepper driver connected with two power source 24v(driver) and 5v(generator) like in the picture
I use PUL-, DIR-, and ENB-, 3 cables connected to the M542 driver
In this setup I should join all pluses together and connect to common anode(+)
I do not why but everything works without this cable - common anode(+).
I am confuse here. I send only positive signals to the module
I can change direction of the motor (DIR) and switch on/off the motor (ENA)
Not the same situation if I use only PUL+ DIR+ ENB + without common cathode this time(-).
Without common cathode I can only run one direction (like having only PUL+ and (-)cathode or PUL- and (+)anode two cables connected)
I can have on/off function (ENA, because module send HI signal and disable(off) the driver.
I know that signal I get is PWM square wave, multimeter allows to check polarity of such a signal (all + or -)
Can anyone explain how this works please, many should benefit too.
System got all function start/stops using ENA and Direction using DIR all done by 3 cable connected to (-) without having common anode(+)
Cheers
TomLast edited by Tom J; 10-01-2016 at 02:02 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How do I wire a stepper driver to a stepper motor?
By swood1 in forum Stepper & Servo MotorsReplies: 7Last Post: 21-09-2014, 05:40 PM -
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
Running a three phase router/mill on a generator?
By gavztheouch in forum General ElectronicsReplies: 3Last Post: 19-02-2013, 12:39 PM -
WANTED: stepper driver module
By tinshak in forum Items WantedReplies: 0Last Post: 16-01-2013, 09:31 AM -
Stepper motor as a generator??
By wiatroda in forum General DiscussionReplies: 10Last Post: 08-08-2011, 10:17 PM
Bookmarks