Thread: Isel CPM 3020 - run with mach3?
Threaded View
-
17-01-2016 #19
Hi Clive and thanks for the welcome.
Sorry I could have been clearer.
I was just saying that if he`s creating his own unregulated PSU then a nominal output of 45v with no load could drop to below 40v under load and if he goes for a 45v output under load then the PSU may well give more than 50v without a load which may be too much voltage for his drives. I`m not sure what protection they have.
This may or may not be an issue, but I thought I would just point out the possibility.
I apologise if I`ve clouded the issue, that was not my intention.
I`m no electronics expert but that is my experience with power supplies.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Vevor 3020 cnc Autolevelling
By iBeta in forum Machine DiscussionReplies: 8Last Post: 22-11-2015, 07:08 PM -
DIY 3020 CNC I/O Board
By Pointy in forum Electronic Project BuildingReplies: 10Last Post: 27-07-2015, 10:48 PM -
NCStudio to Mach3 question for a chinese 3020 router
By Fivetide in forum Chinese MachinesReplies: 3Last Post: 11-04-2015, 10:37 PM -
is a cnc 3020 right for the jobs i need doing
By RsvRcarl in forum Milling Machines, Builds & ConversionsReplies: 3Last Post: 28-03-2012, 01:34 AM -
Improving your CNC3040/3020
By DanielF in forum Motor Drivers & ControllersReplies: 0Last Post: 22-11-2011, 01:48 PM
Bookmarks