. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 11-01-2016 #2
    uli12us's Avatar
    Lives in Dinkelsbuehl, Germany.
    uli12us
    Last Activity: 21-08-2020 Has been a member for 9-10 years. Has a total post count of 117. Received thanks 4 times, giving thanks to others 0 times.
    It depends, a colleague have a Isel machine, this part have DC-Servos with +/-10V. He must only change the controller (BOB) to run it with LCNC.
    If your machine have the same parts, then you can change the controller with an analog controller like Mesa 7i77, CSMIO IP/A, Peco.
    If you have stepper drives then probably, the are controlled via Step/dir.
    In this case a simple BOB is enough.

    Eventually you can tst this SW for the Isel.
    http://www.spline.nl/machines/kay.html
    Last edited by uli12us; 11-01-2016 at 12:27 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 16 users browsing this thread. (0 members and 16 guests)

Similar Threads

  1. Vevor 3020 cnc Autolevelling
    By iBeta in forum Machine Discussion
    Replies: 8
    Last Post: 22-11-2015, 07:08 PM
  2. DIY 3020 CNC I/O Board
    By Pointy in forum Electronic Project Building
    Replies: 10
    Last Post: 27-07-2015, 10:48 PM
  3. NCStudio to Mach3 question for a chinese 3020 router
    By Fivetide in forum Chinese Machines
    Replies: 3
    Last Post: 11-04-2015, 10:37 PM
  4. is a cnc 3020 right for the jobs i need doing
    By RsvRcarl in forum Milling Machines, Builds & Conversions
    Replies: 3
    Last Post: 28-03-2012, 01:34 AM
  5. Improving your CNC3040/3020
    By DanielF in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 22-11-2011, 01:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules