Emco F1-p Mill Mach3 convention, Spindle motor problem

[Clive S]

Andrew You mention photos in your post but they have not uploaded you might be able to edit the post and upload, if not just upload in a new post.

[andre13442]

i did now add a wire diagram from my connetions.

spindle motor and my Mach3 screens

[JAZZCNC]

You have no port number assigned to Spindle.

Can you show the drive because it may need to be enabled.

[andre13442]

the settings in the photos are of the one from whom I bought the machine. I myself had already both "Step Port" and "Dir Port 'changed from 0 to 1. So" step Port "is one and" Dir Port "is 1 but the result remained the same, no rotating spindle motor . I also have afther the change this, Mach3 restarts.
but thanks for your respons.....

[JAZZCNC]

So what about the enable pin on the drive.?

Unlike Steppers drives Servo drives need to be enabled. You say it's not connected. If not then this will most likely be why it's not working.

[andre13442]

the settings in the photos are of the one from whom I bought the machine. I myself had already both "Step Port" and "Dir Port 'changed from 0 to 1. So" step Port "is one and" Dir Port "is 1 but the result remained the same, no rotating spindle motor . I also have afther the change this, Mach3 restarts.
but thanks for your respons.....

[andre13442]

I have placed Some picture, Clive...